Reproduction of GM Part # 1385404 Equalizer Shaft
Copy of the very hard to find original for 1968-72 Buick Skylarks with 400 or 455 cubic inch engines. This part looks close but has problems.
The clutch pedal push rod hole (upper lever). The hole is made for an upper rod with a 3/8" pin. The original rod has a 3/8" pin, but uses a rubber and steel bushing.
The lever is too narrow to drill it out for the original bushing,
If you don't mind having metal on metal contact (about 95% of GM vehicles came that way from the factory) you can use an original rod and shorten the pin or use my part # 353
rod, which is close to the original in length with short 3/8" pins.
Enlarge the 3/8" hole to ?? and press in a smaller than original bushing.
This part is listed well below cost.